Long-Term Maintenance for CTP-S Thermal Plates Daily habits and plate baking
Recalibrate exposure energy. Plate coatings can vary slightly between production lots. Run a test plate and verify dot reproduction across the tonal range before a production run.
💡 Why it matters: A small shift in coating sensitivity can cause dot gain or dot loss if exposure energy isn't re-verified. A 10-minute test plate saves a wasted production run.
For maximum run length — especially with UV ink — plate baking can extend life. The CTP-S supports post-baking. Follow these rules:
| Step | Rule |
|---|---|
| 1. Dry the plate | Ensure the plate is completely dry before baking. |
| 2. Apply conditioner | Apply baking conditioner evenly with absorbent gauze, using gentle strokes. |
| 3. Bake | Bake at the specified temperature and dwell time. Over-baking embrittles the coating. |
| 4. Cool | Allow the plate to cool completely before mounting. |
⚠️ Caution: Baking is not a substitute for correct chemistry. A plate that runs short because of developer problems will not be rescued by baking.
Consistent daily habits beat occasional heroics. A few minutes of checking each day prevents the defects that cost hours of press time later.
If you want to review your processing setup with our technical team, contact us or download the CTP-S datasheet.
Whether you need processing parameters, baking specifications, or a technical review of your setup — BOCICA's team is here to help.
Explore the CTP-S product page and get the specifications you need.
📩 Visit CTP‑S product page →📧 Email: inquiry@bocica.com | 🌐 www.bocica.com